A robust, basic instrument for general laboratory use with all of the advantages of the Spacesaver case. Output signal is adjustable over the full audio range and beyond with a low level of distortion. Coarse frequency control is by way of a rotary-switch spanning four decades and a calibrated tuning dial provides for fine frequency setting. Output level is continuously variable up to a maximum of 2V r.m.s. under open circuit conditions. An audible signal from the built-in speaker can be selected by depressing a front-panel membrane switch. A similar switch enables selection of sinusoidal or square waveform, the status indicated by LEDs. Technical Specifications:. Frequency Range: 10Hz to 110kHz in four decade ranges selected by rotary switch. Wave Forms: Sine or square waveform selected by push switch with LED indication. Sine Wave Distortion: 0.5% typical. Square Wave Rise Time: better than 0.25µs. Output: 0-2V rms (5.6V peak to peak) open circuit. Output Control: Continuously variable, uncalibrated amplitude control. Built-in speaker: switch-selected with LED indicator. Floating output: with separate Earth terminal. Mains switch: rocker switch with indicator light. Dimensions:. Width: 175mm. Diameter: 190mm. Height: 298mm. Mass: 3.1kg. Please be aware that this instrument is suitable for signal investigations, however, it IS NOT SUITABLE for driving a loudspeaker or the Vibration Generator. If you require an instrument for that purpose please refer to our Power Signal Generator (B8G85793). Can be used alongside our Power Amplifier (B8R07696) to drive the Vibration Generator where a Power Signal Generator is unavailable. This device is compliant to EN61010-2010 with certificates available on request.
